Dacor MH30 - Manual (Page 11)

9
Preparing for Installation
duct cut-out for rear venting
Back wall
duct cut-out for top venting
Ceiling or
cabinet
bottom
Installation Instructions
wArning
Do not install the range hood unless the electrical •
service provided meets the range hood specifica-
tions.
Observe all governing codes and ordinances during
•
installation. Contact your local building department
for further information.
A qualified technician must complete the installa-
•
tion of this built-in appliance. More than one person
is required to raise the hood into place. The owner
is responsible to make sure the hood is properly
installed.
Start by removing the filters from the bottom of the 1.
hood. Put them in a safe location so that they will not
be damaged.
If the hood will be installed in a top exhaust configura-
2.
tion, skip to page 16. If the hood will be installed so
that air will exhaust out of the back, the blowers must
be rotated into the correct position before hanging the
hood. The procedure for rotating the blower depends
on the hood model number. See the table at the right.
Blower Rotation Instructions
Model see pAge
EH3012, MH3012, EH3612, MH3612,
EH4212
10
EH4812, MH4812 11
EH3018, MH3018, EH3618, MH3618,
EH4218
13
EH4818, MH4818, EH5418 15