ThunderMax Models w/96”Engine ARB EO # K-001 - Manual (Page 7)

www.Thunder-Max.com 309-375 Installation / Setup Guide V2009.10.30 [email protected] 7
TIPS AND GENERAL INFORMATION
• Several support features are located under the
[Help] menu; some require an internet
connection.
• A comprehensive Tuning Manual in PDF
format is included on the CD for viewing and
printing from your desktop.
• When the SmartLink program is opened, it
will automatically retrieve and open the last map
that was open.
• Any time you link to your motorcycle: Read
the map that is installed in the ThunderMax
ECM by selecting [File] then [Read Module
Maps and Settings] on the SmartLink toolbar.
This will synchronize the map file loaded into the
ThunderMax ECM with the SmartLink software.
• 2007-up Big Twin models: There are two
settings in the [Module Configuration] [Basic
Settings] page that should to be set to the
following to enable the 6
th
gear indicator light to
function:
Final drive ratio [87] Gear 6 Min TPS [40].
• Target air/fuel ratios can be viewed on the
Air/Fuel-TPS @ RPM pages. When these
pages are open, you can view the target AFR by
clicking on a dot and tapping the space bar to
view the target at a specific throttle position for
that RPM. Use arrow keys to raise/lower targets.
• In-Tank Fuel Filters should be inspected as a
part of routine maintenance. The filter is small
and one bad load of fuel can clog it. The factory
recommended service interval is 25K miles.
• Oxygen Sensor Care: Items that can damage
or shorten the life of your sensors:
Leaded fuel – Race fuel
Oil deposits from oil consumption problems
Excessive (extreme) heat
Improper installation (damage)
There is no warranty on sensors damaged by
improper installation or wire chaffing (bare
wires). Replacement P/N is 309-355. See
warranty information sheet for more details.