Toyotomi KS-47B - Manual (Page 8)

ASSEMBLY AND OPERATlON
lNSPECTlON AND ASSEMBLY
NOTE: Save the shipping carton and packing materials for future storage of your heater.
1. REMOVE PACKING MATERIALS
Remove all packing materials from your heater and install the guard as follows:
CAUTION: Risk of burns. Do not operate heater without guard completely attached.
a) Remove the carrying handle, top plate and packing materials.
b) Replace the top plate and install carrying handle by inserting end of carrying
handle to the guard as per illustration.
2. lNSTALL DRIP TRAY
NOTE: DO NOT operate your heater without the drip tray.
Place the drip tray on the floor.
ⅷ
Place the heater on the drip tray.
ⅷ Turn the heater clockwise until the feet slide into their tabs.
3. CHECK SCREWS
Make sure that the three (3) screws around the guard above the fuel tank are tight.
4. INSTALL BATTERIES
Insert the two (2) C size batteries according to the plus (+) and minus (-) markings
inside the holder.
6
KS-47B_US.qxd 14.7.25 13:18 ページ 6