Toyotomi KS-47B - Manual (Page 9)

FUELING
1. lnsert the straight tube of the manual fuel siphon into the kerosene (paraffin)
container. Remove the fuel tank cap on the heater, and insert the siphon's
flexible hose into the fuel tank opening.
2. Turn the air vent knob on the top of the siphon clockwise to close the air vent.
3. To start the flow of kerosene (paraffin), squeeze the bulb of the siphon vigorously
six or seven times. Once the flow begins, it is no longer necessary to squeeze the
bulb. To avoid overfilling the tank, watch the fuel gauge. As the indicator enters
the red zone, stop the flow by turning the air vent knob counterclockwise.
NOTE: Be especially careful to avoid overfilling the tank with very cold
kerosene; otherwise overflow might occur when the fuel warms up.
4. Remove the siphon carefully, allowing the excess kerosene (paraffin) to drain from the tube back into
container. Replace the fuel tank cap and tighten it securely. Be sure to wipe away any spilled kerosene
(paraffin) from tank or other heater parts.
CHECK BEFORE LIGHTING
1. LOCATE YOUR HEATER AWAY FROM WALLS AND AVOID DRAFTS
Allow at least three 90cm of clearance between the heater and walls, curtains, shelving or other
combustible materials. Do not operate your heater in drafty areas or locations where opening doors may
create gusts of air. Drafts or strong air currents may make flame unstable and affect heater performance.
2. LEVEL THE HEATER
The heater should be operated on a firm, Ievel floor.
NOTE: lf your heater is not level, change Iocations. Do not attempt to prop it
up with books or other objects. An unlevel heater may burn with an
uneven flame.
7
WARNING: Use only clean Kerosene (paraffin).
Never use gasoline (petrol) or other flammable liquids.
ALWAYS extinguish heater before refill heater fuel tank.
Fuel heater outside the living area.
More than 90 cm.
More than 90 cm.
More than
90 cm.
More than 90 cm.
More than
90 cm.
USE KEROSENE ONLY
(PARAFFIN)
KS-47B_US.qxd 14.7.25 13:18 ページ 7