Delta 902118 43-505 - Manual (Page 8)

8
6. Place dust hood (P) Figs. 9 and 10, over dust chute
(H) and fasten dust hood to back of fence body (A) using
two M5x10mm sheet metal screws (S), as shown in Fig.
10. NOTE: Dust hood (P) should always be used. Dust
chute (H) is used only with a dust collection system.
Fig. 10
ASSEMBLING
TABLE INSERT
The table insert (A) is assembled in the table, as shown
in Fig. 11.
Fig. 11
FASTENING
ROUTER/SHAPER
TO SUPPORTING
SURFACE
IF DURING OPERATION THERE IS ANY TENDENCY
FOR THE ROUTER/SHAPER TO TIP OVER, SLIDE OR
WALK ON THE SUPPORTING SURFACE, THE ROUT-
ER/SHAPER SHOULD BE SECURED TO THE
SUPPORTING SURFACE. REMOVE THE FOUR
RUBBER FEET ATTACHED TO THE ROUTER/SHAPER,
AND FASTENING THE MACHINE TO THE SUPPORTING
SURFACE WITH FASTENERS (not supplied).
IF YOU PURCHASED THE ACCESSORY STAND, THE
FOUR PLASTIC FEET, SUPPLIED WITH THE STAND,
FEATURE HOLES WHICH ALLOW THE STAND TO BE
SECURED TO A SUPPORTING SURFACE WITH
FASTENERS (not supplied).
P
S
A
H
A
OPERATING CONTROLS AND ADJUSTMENTS
STARTING AND STOPPING
ROUTER/SHAPER
The on/off switch (A) Fig. 14, is located on the front of the
Router/Shaper cabinet. To turn the machine “ON,” move
the switch (A) to the “ON” position. To turn the machine
“OFF,” move the switch (A) to the “OFF” position.
LOCKING SWITCH IN
THE “OFF” POSITION
IMPORTANT: When the machine is not in use, the switch
should be locked in the “OFF” position to prevent
unauthorized use. This can be done by grasping the
switch toggle (B) Fig. 15, and pulling it out of the switch
as shown. With the switch toggle (B) removed, the switch
will not operate. However, should the switch toggle be
removed while the machine is running, it can be turned
“OFF” once, but cannot be restarted without inserting
the switch toggle (B).
Fig. 14
Fig. 15
A
B