VALERA X-STYLE - Manual (Page 3)

5
fallen into water - disconnect the plug from the power socket
immediately.
• Make sure the unit is perfectly dry before using it.
• Do not put the appliance on heat sensitive surfaces during use.
• After use always switch the unit off and remove the plug from the
power supply socket. Do not pull on the wire to remove the plug
from the power supply socket. Do not pull the plug out of the
power supply socket when your hands are wet.
• Always allow the unit to cool before putting it away and never wrap
the cord around the unit.
• Check that the cord has not been damaged from time to time.
• Prevent the cord from coming into contact with the metal parts
while these are still hot.
• Use the unit on dry hair.
• Do not use this unit on wigs that have synthetic hair.
• Do not use your unit if it is not working properly. Do not try to
repair this electrical unit yourself, rather contact an authorized
technician.
• The elements used to pack the unit (plastic bags, cardboard box,
etc.) must be kept out of reach of children as they are a potential
danger to them.
• This unit must only be used for the purposes for which it is
expressly intended. Any other use is to be considered improper
and therefore dangerous. The manufacturer accepts no
responsibility for damage caused by improper or erroneous use.
• Do not use hair spray while the unit is running.
• Keep the plates clean and free of dust, hair spray, styling gel, etc.
• To avoid dangerous overheating, it is advisable to unwind the entire
length of the cord
OPERATING INSTRUCTIONS
Parts - Fig. 1
1. Handle
2. On/Off indicator
3. ON/OFF switch
4. Accessory release buttons
5. Plates opening lock/release
Turning the appliance on and off
To turn the appliance on, just plug it into the outlet and put the switch (fig. 1, ref. 3) on “I”. To turn it off, put
the switch (fig.1, ref.3) on “0” and unplug it.
The appliance has to pre-heat several minutes before use.
Plates opening lock/release - Fig. 2
Changing the accessory - Fig. 3 - 4
Only change the accessory with the appliance switched off and disconnected from the electrical power supply.
When changing accessories, only touch the plastic parts of the appliance of the accessory. Metal parts may
still be hot!
1. Press the accessory release button (4) and remove the accessory from the grip (1).
2. Fit the new accessory and push it firmly into the grip (1) until it clicks into place.
Important: never leave the appliance unattended when on.
Always put the appliance on the pedestal (9) when using the Irons / Plate
6. Straightening plates
7. Irons / plate
8. Small wave plates
9. Irons / plate pedestal
00060549 int_ott2014 30/09/2014 10.33 Pagina 5