Vectronics VEC-221K - Manual (Page 34)

VEC-221K Instruction Manual CW Memory Keyer Kit
28
ENCLOSURE
Vectronics has designed a matching enclosure just for your VEC-221K CW
Memory Keyer Kit. The matching enclosure is an all metal box which includes
knobs, hardware, decals, and rubber feet. Enclosure Model: VEC-221KC.
To install your receiver in the VEC-221KC matching enclosure follow these
instructions (read all instructions before beginning ... take your time):
1. Find the front and rear panel decal; separate using scissors. Put the rear
panel decal on first. This is done by: a.) Remove all debris and oil from the
chassis. b.) Remove the crack and peel to expose the adhesive. c.) Place the
decal on the rear panel without securing it completely. d.) Gently rub the
alignment circles with your finger--if the circles are centered in the enclosure
holes (also check the corner alignment marks) secure the decal by rubbing
and removing all air bubbles. e.) If the alignment circles are not centered,
adjust the decal accordingly, then secure. f.) Use a penknife, or small
Exacto
TM knife, to cut away the unused edges and cut out the component
holes. g.) Repeat procedure for the front panel.
2. Next, install the two L-brackets on the chassis using two of the 3/16" screws.
The longer side of the L-bracket must be connected to the chassis using the
two holes centered on each edge of the enclosure. Refer to the diagram on
the next page for location and orientation.
3. Install the four 1/2" mounting screws next. Insert the screws, from the
bottom, through the two holes close to each rear corner of the chassis.
4. Place the four 3/16" round spacers on the mounting screws.
5. Now insert the PC board. This must be done by: a.) Remove the nuts and
washers from R6 and R8. b.) Insert the front of the PC board at an angle, c.)
then push down on the rear of the board. Make sure the mounting screws
align with the mounting holes in the PC board before pushing.
6. Use the four hex nuts to secure the PC board. Be certain all appropriate
components are centered with the enclosure holes before tightening. Put the
washers and nuts--removed from R6 and R8--back on and tighten.
7. Find the knobs and switch caps. Align the switch cap with SW1 and push it
on. If it is difficult to push on, then rotate it 90° and try again. Repeat for
SW2 through SW6. Now put the knobs on R6 and R8. You may need to
loosen the set screw. Align appropriately then tighten the set screw.
8. The top should now be installed. Use the two remaining 3/16" screws for
securing the top to the L-brackets.
9. Place the four rubber feet on the bottom of the enclosure at the corners.