Vectronics VEC-821KC - Manual (Page 2)

VEC-821KC Assembly Manual Super CW Filter
2
PARTS LIST
The Parts List below is for the VEC-821KC. Please inventory all parts before
beginning case construction.
Parts List
" Qty Part Description
!
1 VEC-821K Cabinet Chassis
! 1 VEC-821K Cabinet Cover
! 1 Kit Decal Set; VEC-821K
! 3 Flat Metal Washer; .416"x.625"x.062"
! 1 9MM Hex Nut
! 4 4-40 Hex Nuts
!
1 1/4" Mono Phone Jack
! 1 Screw-on Terminal Strip
! 1 1" x 1" Double -Sided Tape
! 4 Round Rubber Feet
! 2 Small Tapped "L" Brackets
! 6 4-40 x 3/16" Phillips Machine Screws
!
2 #4 x 3/16" Round Aluminum Spacers
! 1 3/8" Hex Nut
! 2 4-40 x 1/2" Phillips Machine Screws
! 1 9 Volt Battery Clip
In addition to the above pieces of hardware, you should still have a thin steel flat
washer, a 3/8" hex nut. These parts were left over from the VEC-821K kit. You
were asked not to discard them, because they will be needed when you installed
the circuit board in an enclosure. If possible, locate them.