Zektor Clarity Prowler™ - Manual (Page 12)

12 Prowler 8x8 User Guide, Version 1.4, 7/15/11
Front Panel Commands
Front Panel Commands
Turning the Prowler 8x8 on or off
To power on the Prowler 8x8 press the POWER toggle button.
To power off the Prowler 8x8, press and hold the POWER button, for about 2 seconds, until the Prowler
8x8 powers off.
Mapping an input to an output zone
To map any input to any zone (output):
1 Select the zone or zones to be mapped by pressing one or more of the zone buttons . When
a zone is selected the zone’s LED will flash (allowing the selection to be seen easily from
across the room) and its decimal point will light up. By pressing a flashing zone’s button
again, you can unselect the zone.
2 Once a zone (or zones) have been selected, pressing an input button , maps the chosen
input to the selected zone(s). By pressing and holding buttons 1 - 3, the composite to compo-
nent converters A, C and E can be selected.
3 The zone LED(s) will stop flashing, but will remain selected, (the decimal point will remain
lit). To remap the currently selected zone(s) to a different input, simply press another input
button.
Since there are only 8 audio inputs and 11 video inputs, when switching to the three composite to com-
ponent converters, the video break away feature is automatically enabled, and only the video will
switch to the converters. The audio will remain at it’s current setting.
Audio and video inputs will only change when the proper VID and AUD LED s are lit, see the next section
on audio / video break away for more information.
A
       
AUDIO VIDEO MATRIX SWITCH
AUD
VID
MEM 1 2 3 4
CLR 5 6 7 8 ENT 1 2 3 4 5 6 7 8
A C
D
B
C
D
B