Ip address and baudrate selection, Front panel commands – Zektor Clarity Prowler™ User Manual

Page 19

Advertising
background image

Prowler 8x8 User Guide, Version 1.4, 7/15/11

19

Front Panel Commands

IP Address and Baudrate Selection

To adjust the IP address:

1

Enter the setup mode to by pressing and releasing the power toggle button

, the display will

fill with ‘-’ characters, indicating you are now in the extended setup mode.

2

To save new settings press the ENT button

at anytime. All new settings will be saved in

non-volatile memory are are retained after a power failure. Or, to cancel the setup mode and

lose all changes, press the power toggle button

. All changes made will be lost!

3

Enter the communication setup mode by pressing the in select ‘5’ button

. The display will

now show the upper two octets of the IP address.

4

The IP address is made up of four “octets”, the default IP address of the Prowler 8x8 is:
192.168.001.200. Each octet is a number between 0 and 255.

To switch between displaying the upper two octets and the lower two octets, use the ‘4’

and ‘8’

buttons. Use the zone buttons under each octet to adjust the value:

Any zone button under an octet in the 1’s position

will increment the value by 1.

Any zone button under an octet in the 10’s position

will increment the value by 10.

Any zone button under an octet in the 100’s position

will decrement the value by 1.

Values will wrap around. Incrementing past 255 will cause a value to wrap to 0. Decrementing
below 0 will cause the number to wrap around to 255.

5

You must press the ENT button

to save the new IP address!

To change the serial port’s baudrate:

1

Perform above steps 1 and 2. The zone LEDs should now be displaying the upper two octets of
the IP address.

2

Press the source ‘1’

button, the zone LEDs will now display the current baudrate setting.

There are two selectable baudrates, 19200 and 9600. The default baudrate is 19200.

3

To switch between the two baudrates, use the ‘4’

and ‘8’

buttons.

4

Once set, you must press the ENT button

to save the new baudrate!

  

  

AUDIO VIDEO MATRIX SWITCH

AUD

VID

MEM 1 2 3 4

CLR 5 6 7 8 ENT 1 2 3 4 5 6 7 8

B

A

G

E

H

C

F

I

D

A

D

A

B

I

C

G

F

E

D

H

I

C

D

Advertising
This manual is related to the following products: