Electrical device compliance notices, Safety warnings and cautions, Electrical – Adtec digital EN-30 (version 1.02.02) Manual User Manual

Page 5: Device, Compliance, Notices, Safety, Warnings, Cautions

Advertising
background image

Electrical Device Compliance Notices

Safety Warnings and Cautions

For your safety and the proper operation of the device:

●

This unit must be installed and serviced by suitably qualified personnel only.

●

Do not break the warranty seals on the device or open the lid. Only approved service
technicians are permitted to service this equipment.

●

Disconnect all power before servicing the unit.

●

Do not expose this device to rain or other moisture. Clean only with a dry cloth.

●

If not installed in an equipment rack, install the product securely on a stable surface.

●

Install the product in a protected location where no one can step or trip over the
supply cord, and where the supply cord will not be damaged.

●

If a system is installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than the room ambient
temperature.

●

Consideration should be given to installing the unit in an environment compatible
with the maximum recommended ambient temperature of 50 degrees Celsius (122
degrees Fahrenheit).

●

Install the unit in a rack so that the amount of airflow required for safe operation is
not compromised.

○

The recommended clearance on the top and sides of the unit is at least ½ “
(one half inch/one centimeter).

●

Mounting of the unit in a rack should be such that no hazardous condition is achieved
due to uneven mechanical loading.

●

Use only a grounded electrical outlet when connecting the unit to a power source.

●

Reliable earth grounding of rack-mount equipment should be maintained.

○

Particular attention should be given to supply connection other than direct
connections to the branch circuit (e.g., use of power strips).

Advertising