Datalogic Scanning Single Ethernet Cradle Datalogic Memor User Manual

Page 2

Advertising
background image

RS232 CONNECTION


The Datalogic Memor™ Single Ethernet Cradle can be connected to the
host by means of any standard null modem cable. The 9-pin female D-
Sub connector must be connected to the RS232 port of the cradle.

Once the host has been turned on, insert the Datalogic Memor™
mobile computer into the cradle.

Figure 5 - RS232 Connection

A) Host

Computer

C) Datalogic Memor™ Single

Ethernet Cradle

B)

Null Modem cable

D)

*Power Supply (only necessary
for battery charging)

* Recommended power supply: 94ACC1324 PG5-30P35 AC/DC

POWER SUPPLY EU/USA PLUG.

NOTE

Be sure that the switch is in the “USB” position.
During switch operation from USB position to Ethernet
position and vice versa the mobile computer must not be
inserted in the cradle.

ETHERNET CONNECTION


Connect the Ethernet cradle (Ethernet port ) to an Ethernet hub or a port on
the host device. Connect the Power jack to a power supply*.

Figure 6 - Ethernet Connection

A) Datalogic

Memor™

Single Ethernet Cradle

C)

UTP CAT 5E cable
(recommended use)

B)

Ethernet hub

D)

*Power supply


*

Recommended power supply: 94ACC1324 PG5-30P35 AC/DC
POWER SUPPLY EU/USA PLUG.

NOTE

Be sure that the switch is in the “Ethernet” position
During switch operation from USB position to Ethernet
position and vice versa the mobile computer must not be
inserted in the cradle.

NOTE

You may need to set the cradle configuration or the
terminal behaviour using respectively the "Cradle
Manager"

Windows XP application

and the

"CPCradleCE" Windows CE application. You can
download the "Cradle
Manager" installation file and the
full "Datalogic Memor
Single Cradle User Guide" from
the Datalogic Mobile website:
www.mobile.datalogic.com.

TECHNICAL FEATURES

Datalogic Memor™ Single Ethernet Cradle

Electrical Features
Power Supply*

5 VDC ± 5%

Consumption

Max. 2.5 A

Indicators

Power on LED (green)
Spare battery charge LED (bi-colored)
Ethernet LEDs (green and yellow)

Charge Time

1000 mAh Battery: max. 3 hours
2000 mAh Battery: max. 6 hours with terminal
inserted, max. 4.5 hours without terminal

Communication Features
Interface

RS232, USB 1.1 version, Ethernet

Baud Rate

RS232 = up to 115200 b/sec; USB = up to 12
Mb/sec; Ethernet = up to 10 Mbps

Environmental Features
Working Temperature**

0° to +50 °C (+32° to +122 °F)

Storage Temperature

-20° to +65 °C (-4° to +149 °F)

Humidity

80% non condensing

Degree of Protection

IP50

Mechanical Features
Dimensions

105 X 75 X 102 mm (4.13 X 2.95 X 4.02 in)

Weight

340 g (12 oz)

*

Recommended power supply: 94ACC1324 PG5-30P35 AC/DC
POWER SUPPLY EU/USA PLUG.

** Battery must be charged at a temperature ranging from 0° to +45

°C (+32° to +113 °F).

FCC COMPLIANCE


Modifications or changes to this equipment without the expressed
written approval of Datalogic could void the authority to use the
equipment.
This device complies with PART 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference which may cause undesired operation.

This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.

Datalogic Mobile S.r.l.

Via S. Vitalino 13

40012 - Lippo di Calderara

Bologna - Italy

07


dichiara che
declares that the
déclare que le
bescheinigt, daß das Gerät
declare que el

DL-Memor Single Ethernet Cradle

e tutti i suoi modelli

and all its models

et tous ses modèles

und seine Modelle

y todos sus modelos


sono conformi alle Direttive del Consiglio Europeo sottoelencate:
are in conformity with the requirements of the European Council Directives listed below:
sont conformes aux spécifications des Directives de l'Union Européenne ci-dessous:
den nachstehenden angeführten Direktiven des Europäischen Rats:
cumple con los requisitos de las Directivas del Consejo Europeo, según la lista siguiente:

89/336/EEC EMC Directive

e 92/31/EEC, 93/68/EEC

emendamenti successivi

and

further amendments

et

ses successifs amendements

und

späteren Abänderungen

y

succesivas enmiendas


Basate sulle legislazioni degli Stati membri in relazione alla compatibilità elettromagnetica ed alla
sicurezza dei prodotti.
On the approximation of the laws of Member States relating to electromagnetic compatibility and product
safety.
Basée sur la législation des Etats membres relative à la compatibilité électromagnétique et à la sécurité
des produits.
Über die Annäherung der Gesetze der Mitgliedsstaaten in bezug auf elektromagnetische Verträglichkeit
und Produktsicherheit entsprechen.
Basado en la aproximación de las leyes de los Países Miembros respecto a la compatibilidad
electromagnética y las Medidas de seguridad relativas al producto.


Questa dichiarazione è basata sulla conformità dei prodotti alle norme seguenti:
This declaration is based upon compliance of the products to the following standards:
Cette déclaration repose sur la conformité des produits aux normes suivantes:
Diese Erklärung basiert darauf, daß das Produkt den folgenden Normen entspricht:
Esta declaración se basa en el cumplimiento de los productos con la siguientes normas:

EN 55022 ( C

LASS

B ITE ), S

EPTEMBER

1998:



INFORMATION TECHNOLOGY EQUIPMENT

RADIO DISTURBANCE CHARACTERISTICS

L

IMITS AND METHODS OF MEASUREMENTS

EN 55024, S

EPTEMBER

1998:

I

NFORMATION

T

ECHNOLOGY

E

QUIPMENT

EN 55024/A1, O

CTOBER

2001:

I

MMUNITY CHARACTERISTICS

EN 55024/A2, J

ANUARY

2003:

L

IMITS AND METHODS OF MEASUREMENTS

Lippo di Calderara, March 9th, 2007

Paola Chientaroli

Quality Assurance Manager

A

B

C

D*

D

A

C

B

Advertising