Amina ALF120 - Manual (Page 10)

10
In-wall installation
Making good the wall
Cutting the outlet slot
Mark up the position of the outlet slot •
using the dimensions shown in the
drawings below.
The slot must be 309mm wide x 15mm
tall, located on the centre-line of the
ALF120.
309mm
15mm
The bottom edge of the slot sits 18mm •
above the stud under the ALF120.
Skirting
Cut a section of skirting (where used) •
and repeat the process to cut a slot of
the same size in the same position.
Fit the skirting to complete the
•
installation.
Check that the slot aligns with the •
opening at the base of the ALF120.
The wall can now be made good and
•
plastered.
18mm
Stud
height
height o
f s
tud
p
lus 18mm
16mm 15mm
14mm
Trim
Gasket
Port Plate
Felt Pads
Timber Stud
Skirting
Dry Wall