Amina ALF120 - Manual (Page 9)

9
In-wall installation
Making good the wall
Preparing the wall panel
The wall may be a new build or you could
have opened a cavity in an existing wall
to install the ALF120. In either case it is
now necessary to build/re-build the wall
to complete the installation.
Cut the section of wall board that will •
cover the ALF120.
Offer up the cut wall panel in the
•
position where it will cover the
ALF120.
Mark up the position of the centre line
•
of the ALF120.
Panel
covering
the
ALF120
Centre-line
of the
ALF120
Fitting the gasket
Lift off the wall panel and place the •
gasket in the position shown at the
base of the ALF120.