Desa 14,000 - Manual (Page 19)

19
101813
INSTALLATION
Continued
2. Locate pre-drilled holes at bottom of each side of mantel (see Figure 23). Use
an electric drill with 1/8" drill bit. Insert drill bit into pre-drilled holes in mantel
and drill through heater hearth base. Make sure the drill bit does not damage
any gas plumbing lines inside hearth base.
3. Locate two 2" screws from hardware package. Insert screws through pre-drilled
holes at bottom of each side of mantel (see Figure 23). Tighten each screw into
the heater hearth base. Make sure the screw tips do not damage any gas plumb-
ing lines inside hearth base.
Note: The pre-drilled holes are countersunk.
Tighten the screws all the way into the holes.
4. Locate two wood plugs from hardware package. Insert plugs into screw holes
(see Figure 23). Tap into place.
Hearth Base
Accessory
2" Screw
Wood Plug
Pre-Drilled
Hole
Figure 23