Aplex Technology APC-3793P - Manual (Page 15)

APC-3x93P_R (SBC-7106A) User Manual 15
Procedures of CMOS clear:
a) Turn off the system and unplug the power cord from the power outlet.
b) To clear the CMOS settings, use the jumper cap to close pins 1 and 2 for about 3
seconds then reinstall the jumper clip back to pins open.
c) Power on the system again.
d) When entering the POST screen, press the <F1> or <DEL> key to enter CMOS Setup
Utility to load optimal defaults.
e) After the above operations, save changes and exit BIOS Setup.
Model JP3
SBC-7106A-N26 No
SBC-7106A-D25 Yes
SBC-7106A-D25P Yes
6. BAT1:
(1.25mm Pitch 1x2 box Pin Header) 3.0V Li battery is embedded to provide power for
CMOS.
Pin# Signal Name
Pin1 VBAT
PIN2 Ground
7. DC_IN1:
(5.08mm Pitch 1x3 Pin Connector),DC9V~32V System power input connector.
Pin# Power Input
Pin1 DC+9V~32V
Pin2 Ground
Pin3 FG
Model DC_IN1
SBC-7106A-D25 180°Connector
SBC-7106A-D25P 45°Connector
SBC-7106A-N26 180°Connector
8. BT1/BT2:
Power on/off button, They are used to connect power switch button. The two pins are
disconnected under normal condition. You may short them temporarily to realize system
startup & shutdown or awaken the system from sleep state.