Argox AS-8000 - Manual (Page 11)

6
Programming the ArgoScan 8000
Series Scanner
To program the 8000 series scanner, you must scan a series
of programming barcode in the correct order. Fold out the
back cover of this manual. You will see a table of
alphanumeric barcodes, which are used to program the
various options presented.
To program each option, you must:
1. Scan the Program barcode on the parameter setting part.
2. Enter the option mode by scanning the Option Bar Code
(also on the Parameter setting part).
3. To the right of the option barcode, the necessary
alphanumeric inputs are listed. Scan these alphanumeric
entries from the back fold out page. To confirm above
steps, you must scan the Finish barcode on the back fold
out page.
4. Once you have finished programming. Scan the Exit
barcode, listed on the lower right hand corner of each
parameter setting part.