Argox AS-8000 - Manual (Page 23)

18
Indication
Power on alert: After power-on the scanner it will generate
an alert signal to indicate a successful self-test.
LED indication: After each successful reading, the LED
above the scanner will light up to indicate a good barcode
reading.
Beeper indication: After each successful reading, the
scanner will beep buzzer to indicate a good barcode reading,
and its Beep loudness, Beep tone freq. and Beep tone
duration are adjustable.
Beep loudness/Beep tone freq./Beep tone duration: You
can adjust Beep Loudness, Beep tone and Beep duration for
a good reading upon favorite usage.
<note > In Beep tone frequency setting, 00~10 are used to
set to Melody 0~10 and not for tone frequency 0~1000 Hz.
The other values from 11~99 are defined as the beep tone
frequency.