Troubleshooting, I'm not getting on the internet (all connections), I'm not getting on the internet (ethernet) – ARRIS DG1680A-TW Users Guide User Manual

Page 34: I'm not getting on the internet (wireless), Chapter 7 troubleshooting

Advertising
background image

Chapter 7

Troubleshooting

The Data Gateway is plugged in, but the Power light is Off

Check all power connections. Is the power cord plugged in firmly at both ends?
If you plugged the power cord into a power strip, make sure the strip is switched on.
Avoid using an outlet controlled by a wall switch, if possible.
Finally, check the fuse or circuit breaker panel.

I'm not getting on the Internet (all connections)

It may take over 30 minutes to establish a connection the first time you power up your

Data Gateway, especially when many people are online. Always leave your Data Gateway

plugged into AC power and connected to the cable system.
Check the front panel lights:

The Power and Online lights should be on.

If the Power light blinks for more than 30 minutes, call your cable company for

assistance.

Check your cable connections. Connectors should be tight. The coax cable should not be

pinched, kinked, or bent sharply—any of these can cause a break or short in the cable (you

may have to replace the cable). If you have one or more splitters between the Data Gateway

and CATV outlet, remove the splitters and connect the Data Gateway directly to the outlet.
Proceed to the Ethernet or wireless solutions if necessary.

I'm not getting on the Internet (Ethernet)

If you are using a hub, is the hub turned on?
Are you using the right type of Ethernet cable? Use the supplied cable for direct connection

to a computer; use a cross-over cable for connection to a hub.
Press the Reset button on the back of the Data Gateway.
A misconfiguration could lock out all access to the Data Gateway router. If you think this

has happened, see

Resetting the Router to Factory Defaults

(page 33).

I'm not getting on the Internet (Wireless)

Check the indicator lights, see Using the Data Gateway — the Wi-Fi light should be on.
Does your connection utility discover your wireless LAN? If you turned off “Broadcast

SSID” you need to manually enter the name of your wireless LAN in the connection utility.

Release 16 STANDARD 1.3 March 2015

Touchstone DG1680 Data Gateway User Guide 34

Advertising
This manual is related to the following products: