Controls, indicators and connectors, 1 face plate, 1 leds – Artesyn Centellis 2000 User Card-10GE Installation and Use (May 2014) User Manual
Page 31: Table 3-1, Face plate leds, Figure 3-1, Face plate, Chapter 3
Chapter 3
Centellis 2000 User Card-10GE Installation and Use (6806800H33C)
31
Controls, Indicators and Connectors
3.1
Face Plate
The following figure highlights the position of LEDs and connectors on the face plate of the
board. The LEDs and connectors are described in sections
and
3.1.1
LEDs
The following LEDs can be found on the face plate of the board. OOS, OK and H/S are ATCA LEDs
and can be controlled via IPMI. For more information, see the Centellis 2000 User Card-10GE:
Control via IPMI Programmer’s Reference manual.
Figure 3-1
Face Plate
Table 3-1 Face Plate LEDs
LED
Color
Description
OOS (failure)
Red
Red: The Centellis 2000 User Card-10GE is out-of-service.
Off: The Centellis 2000 User Card-10GE is working properly.
OK (power)
Green
Green: The Centellis 2000 User Card-10GE is operating
properly.
Off: Otherwise
Blinking: The board boots up.
H/S
Blue
Blue: The Centellis 2000 User Card-10GE is ready to be
extracted.
Off: The Centellis 2000 User Card-10GE is not ready to be
extracted. Do not remove the board during this state.