Artesyn COMX-P2020 Installation and Use (February 2015) - Manual (Page 40)

Hardware Preparation and Installation
COMX-P2020 Module Installation and Use (6806800K97E) 40
Installing the COM Express Module on the Carrier Board
1. Line up the board-to-board connector of the COMX-P2020 Module assembly with
the board-to-board connector of the carrier board.
2. Make sure that the interconnectors are properly aligned and that the bottom
surface of the COMX-P2020 Module have contact with the four standoffs on carrier
board.
3. From the topside of the COMX-P2020 Module assembly, locate the screw holes on
heat spreader/cooler.
4. Use the screws to fasten the COMX-P2020 Module assembly to the carrier board.
Removing the COM Express Module from the Carrier Board
1. From the topside of the COMX-P2020 Module assembly, locate the four screws that
connect the COMX-P2020 Module assembly to the carrier board.
2. Loosen and remove the screws.
3. While holding the edges, pull the COMX-P2020 Module from the carrier board.