Artesyn COMX-P2020 Installation and Use (February 2015) - Manual (Page 93)

Firmware Upgrade
COMX-P2020 Module Installation and Use (6806800K97E) 93
CPU0:1200 MHz, CPU1:1200 MHz,
CCB:400 MHz,
DDR:400 MHz (800 MT/s data rate) (Asynchronous), LBC:25 MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
I2C: ready
SPI: ready
DRAM: 2 GB
L2: 512 KB enabled
MMC: FSL_ESDHC: 0
*** Warning - bad CRC, using default environment
EEPROM: NXID v0
PCIE3 connected to Slot0 as Root Complex (base addr ffe08000)
PCIE3 on bus 00 - 00
PCIE2 connected to Slot 1 as Root Complex (base addr ffe09000)
PCIE2 on bus 01 - 01
PCIE1 connected to Slot 2 as Root Complex (base addr ffe0a000)
Current Status: LSR-11, LTSSM-16, PEX width-x1, Clock-2.5GT/s
Scanning PCI bus 03
03 00 18ca 0027 0300 00
PCIE1 on bus 02 - 03
In: serial
Out: serial
Err: serial
Net: eTSEC1, eTSEC2, eTSEC3
Hit any key to stop autoboot: 0
=>
4. Set the u-Boot environment variables for the network settings through the
terminal:
=> setenv ethaddr 00:01:af:12:23:01
=> setenv ipaddr 192.168.0.253
=> setenv netmask 255.255.255.0
=> setenv gatewayip 192.168.0.1
=> setenv serverip 192.168.0.197
=> setenv ethact eTSEC1
=> ping 192.168.0.197
Enet starting in 100BT/FD