Artesyn MVME2500 VxWorks 6.8 AMP User Guide (August 2014) User Manual
Page 12
Booting VxWorks
MVME2500 VxWorks 6.8 AMP User Guide (6806800M27B)
12
setenv gatewayip 10.130.101.254
setenv netmask 255.255.255.0
3. Set the VxWorks boot image file name.
setenv vxbootfile
vxWorks_00.st
4. Set the VxWorks bootline arguments.
setenv vxbootargs 'motetsec(0,0)10.130.101.216:vxWorks
h=10.130.101.216 e=10.130.101.206:ffffff00 u=vxworks
pw=vxworks f=0x80’
Parameters description:
motetsec(0,0)
: ethernet interface 0 on cpu 0
10.130.101.216
: Host Machine IP
10.130.101.206
: Board IP
ffffff00
: Netmask
u=vxworks
: Username on host machine
p=vxworks
: Password for the above user in host machine
f=0x80
: File Transfer Protocol (FTP)
5. Set the VxWorks network boot command.
setenv vxboot 'tftpboot $vxbootfile && setenv bootargs
$vxbootargs && bootvx
'
6. Save your current environmental variables.
saveenv
7. Boot VxWorks on Core 0 through network .
run vxboot
This will boot the VxWorks on Core 0 only.
For sample output of Vxworks booting on Core 0 through network , refer
8. Boot VxWorks Image on Core 1, execute wrload command.
Example: wrload "-file <image dir>/vxWorks -cpu 1"
To access the Core1 Console use the tip utility.