Artesyn MVME2500 VxWorks 6.8 AMP User Guide (August 2014) User Manual
Page 16
Booting VxWorks
MVME2500 VxWorks 6.8 AMP User Guide (6806800M27B)
16
10.130.101.216
: Host Machine IP
10.130.101.206
: Board IP
ffffff00
: Netmask
u=vxworks
: Username on host machine
p=vxworks
: Password for the above user in host machine
f=0x80
: File Transfer Protocol (FTP)
5. Set the VxWorks USB boot command.
setenv vxusbboot 'usb reset && fatload usb 0:1 0x1000000
$vxbootfile && setenv bootargs $vxbootargs && bootvx'
6. Save your current environmental variables.
saveenv
7. To boot VxWorks on Core 0 through USB, execute the following command:
run vxusbboot
This will boot VxWorks on Core 0 only.
For sample output of VxWorks booting on Core 0 through USB, refer
8. Boot VxWorks Image on Core 1, execute wrload command.
Example: wrload "-file <image dir>/vxWorks -cpu 1"
To access the Core1 Console use the tip utility
Example: tip "dev=/ttyMsd0#tag=green". For more information refer the
tip utility documentation.
For sample output of VxWorks booting on Core 1 through USB, refer
.