Installation – Avalon Firestyles AGP Pellet User Manual
Page 10
10
Installation
(For Qualified Installers Only)
© Travis Industries
4141230
100-01341
Electrical Requirements
This
heater
requires a standard 120 volt, 60 Hz grounded electrical outlet. Do not use an
adapter plug or sever the grounding plug.
This
heater
requires correct polarity. The line (hot) is on the right and has a smaller plug. The
neutral (common) is on the left and has a larger plug. Use a circuit tester (available at hardware
stores) or contact an electrician to verify correct polarity and grounding.
WARNING: CONNECTION TO A REVERSE POLARITY OR UN-GROUNDED CIRCUIT MAY
DAMAGE YOUR HEATER’S CIRCUIT BOARD. THIS MAY CAUSE A SAFETY HAZARD,
IMPROPER OPERATION, AND VOID YOUR WARRANTY.
Do not route the electrical cord underneath, in front of, or over the heater.
HINT: Travis Industries manufactures a Insert Wiring Kit (97200315) that allows the power cord to
be routed through the fireplace, concealing the power cord.