Avalon Firestyles D-V-1995 User Manual
Page 22
P
AGE
22
I
NSTALLATION
(
CONT
.)
Glass Installation
Install the glass by following the instructions on page 20 in reverse order. NOTE:
¥
The glass clips should be in place with the nuts threaded two turns onto the attachment studs.
¥
The gasket must be pliable and follow the perimeter of the firebox opening.
¥
After the glass and trim is in place, align the glass so it is centered and the pieces of glass insert
fully into the trim
¥
Tighten the glass clips on the center piece of glass first.
Glass
Glass Gasket
(5/8" self-adhesive gasket)
Glass Clip
Glass Clip
Attachment Studs
Face of Heater
Cross Section of Glass Attachment
5/16" Nutdriver
Glass Clip Nuts
(use a 5/16" nutdriver
to remove)
If the gasket does not stay in place,
use stove gasket cement to re-attach
or use a new gasket.
Make sure the gasket is not
pinched underneath the glass clip.
NOTE:
NOTE:
Door Installation
Place the door on the stove (see page 6 for details).
!
Clean the door with a soft piece of cloth and denatured alcohol. Other cleaners may leave a film.
Marks left on the gold may become etched in place if not cleaned before starting the stove.
Leak, Pilot, and Flame Testing
!
Leak test all gas line joints leading to the gas control valve. Correct any leaks. Start the pilot flame
and main burners (see the directions on page 25 & 26 if uncertain). Leak test all gas line joints
leading from the gas control valve to the burner pan. Correct any leaks. Turn the flame adjust knob
to its highest position - the flames should be a between 8" and 11". Check the flame on low position.
The flames should burn off of each burner hole. Turn the main burner off and check the pilot flame
to make sure it burns correctly (see the picture on page 28).