Avalon Firestyles DVS Insert EF-2001 to 2005 - Manual (Page 13)

Installation
(for qualified installers only)
1 3
© Travis Industries
4041213
1 0 0 - 0 1 1 5 0
Installation Without Surround Panels
a
b
c
Keep the jumper wire in
place while installing.
Disconnect the on/off switch from
the red and brown wires. Insert
the switch into the hole until it
locks in place. Re-attach the red
and brown wires (orientation does
not matter).
Use a knife to cut out the on/off switch hole
(the label covers a square hole in the bracket).
Use a lock tie or
other device to
bundle the
excess wire.
Then tuck it
below the piezo
igniter to keep it
from coming in
contact with the
burner pan.
The insert may be installed without surround panels if a
3/8" gap is allowed between the sides and top of the
face and the fireplace (for ventiliation). Wire mesh
screen may be placed over this gap.
Min. 3/8"
Face Sizing:
See page 9 for face dimensions.
Surround Panel Installation
π
PANEL SIZE W I D T H H E I G H T PART #
8" x 10" 40-3/8" 28-7/8" 98500610
10" x 13" 44-3/8" 31-7/8" 98500611
Arched 8" x 10" 40-5/16" 28-7/8" 98500622
! Turn the gas source off prior to installing.
1 With the gas line and vent attached, install the side panels (see the illustration below).
Line up each side surround
panel and insert two screws from
the outside to secure in place.
b
a
5/16" Nutdriver
Pre-thread the holes on the panel mounting
brackets with the screws included in the
surround panel kit (both sides).
Run the wires from
the on/off switch and
the power cord
behind the surround
panel (cut the lock-
tie holding the on/off
switch in place).
NOTE:
You may need to
pull the insert out
slightly while
installing the side
surround panels -
do not damage the
gas line or vents.