Avalon Firestyles DVS Insert EF-2001 to 2005 - Manual (Page 7)

Installation
(for qualified installers only)
7
© Travis Industries
4041213
1 0 0 - 0 1 1 5 0
Installation Warnings:
! Failure to follow all of the requirements may result in property damage, bodily injury, or even death.
! This heater must be installed by a qualified installer who has gone through a training program for the
installation of direct vent gas appliances.
! This appliance must be installed in accordance with all local codes, if any; if not, follow ANSI Z223.1
and NFPA 54(88) in the USA and B-149 in Canada.
! In Manufactured or Mobile Homes must confirm with: In USA, Manufactured Home Construction and
Safety Standard, Title 24 CFR, Part 3280; In Canada, CSA Z240.4 and Gas-Equipped Recreational
Vehicles and Mobile Housing. This appliance may be installed in Manufactured Housing only after the
home is site located.
! The DVS Insert is designed to operate on natural gas (NG) or propane (LP).
! All exhaust gases must be vented outside the structure of the living-area. Combustion air is drawn
from outside the living-area structure.
! Notify your insurance company before hooking up this heater.
! The requirements listed below are divided into sections. All requirements must be met
simultaneously. The order of installation is not rigid – the qualified installer should follow the
procedure best suited for the installation.
Items Required for Installation
• Direct Vent Adapter (Simpson Duravent Part # 923GK)
• Face
• Gas Hookup Equipment
• Surround Panels (Optional - see “Installation without Surround Panels”)
• 3” UL 441 Gas Liner
• Direct Vent Cap (Simpson Duravent Part # 991)
Packing List
• DVS Insert
• Log Set (Log Set, Coals, and Embers)
• Owner's Manual
• Propane Conversion Kit
• Two Leveling Bolts
• 8" Pipe Inlet (3/8" dia.)
• "Fireplace Altered" tag (attach to the fireplace)
Items Packed with the Face
• Face (with attachment hardware)
• Face Installation Instructions
Order of Installation
1 If the heater is to use propane, install the propane conversion kit (see page 31)
2 Install gas line into the fireplace (do not connect to unit)
3 Position the heater (see "Insert Placement")
4 Connect the gas line and gas vent to the appliance.
5 Install the optional surround panels and trim. Attach the on/off switch.
6 Follow the instructions under "Finalizing the Installation" on pages 17 through 20.