Avery Dennison 9406 Messages Manual - Manual (Page 13)

Host Error:
Not Ready. You are trying to communicate
with a host, but the host is not
ready.
Make sure:
•
the host is turned on
•
the communications cables
are connected correctly
•
communications are active.
Then re-transmit the data.
Host Error:
Overrun. One of the following flow control
problems occurred between the
printer and the host:
•
The flow control settings on
the printer and the host do not
match.
•
The printer is receiving
information from the host
faster than it can process it.
•
The printer received an
incorrect flow control character.
Make sure the printer and the
host flow control settings match
(both are DTR or both are
Xon/Xoff). If the message
persists, call Monarch Service.
Host Error:
Parity. The parity on the printer does not
match the parity on the host.
Set the printer’s parity to match
the host’s parity.
Invalid Command!
Press ENTER. You tried to delete a packet from
read-only memory.
O
p
erat
io
n
M
essag
es
3. Operation Messages
3-7