Avery Dennison 9450 RASCAL Wall Chart - Manual (Page 4)

For on-demand (peel mode) printing, continue with these steps:
8. Squeeze the tabs on both sides of
the support frame and pull it open.
9. Feed the supply behind the support
frame.
10. Remove labels from the backing
paper.
11. Snap the support frame back into
place. Gently pull on the backing
paper to make sure it is tight.
For supplies, sales and service, call TOLL FREE:
1-800-543-6650 (In the U.S.A.)
1-800-263-4650 (In Canada)
www.monarch.com
TRADEMARK
Monarch and Rascal are registered trademarks and 9450 is a trademark of Monarch Marking Systems, Inc.
LED INDICATOR TROUBLESHOOTING REFERENCE
GREEN solid on-demand mode and ready
second blinking label ready to dispense
2 second blinking low/dead battery
AMBER solid continuous mode and ready
second blinking online error (ex: syntax error)
2 second blinking printhead overheating
GREEN/AMBER second blinking hardware error (ex: printhead open)
2 second blinking firmware failure
Support
Frame
Supply