Avery Dennison 9460IP - Manual (Page 12)

12
6. Connect the printer’s radio harness to the printer’s serial port.
7. Turn on the printer.
The IP printer is ready to use.
NOTE: Do not change any of the communication settings on the printer
itself. Changing those values causes the printer to stop
communicating!
C h e c k i n g t h e I P A d d r e s s
1. Turn on the printer by pressing and holding the power button ( P) until
the display turns on. The display flashes printer version information and
battery charging status.
E B F
Init
card
When you see “Init Card” each dot that appears after the word “card”
is a try for a network connection. Next, you may see
Ready
p <T>
The <T> on the display indicates the printer is connected to a
network (peer to peer or infrastructure mode). indicates the printer
is not connected to a network.
2. When you see “Ready,” press the Center navigational button ( A under
<T> icon) to display the printer’s IP address. Press any button to
return to Ready mode.
Radio Harness
Serial Port