Avery Dennison 9460IP - Manual (Page 6)

6
C o n f i g u r i n g t h e R F I n t e r f a c e
Setting a Name and ESS ID
1. Enter a Unit Name. Use a
meaningful name, for
example, WHSEFLR.
2. Enter the 802.11(b) ESS ID.
NOTE: The ESS ID address is
case-sensitive.
3. Enter a valid address for the
Remote IP (even if you are
not using the remote IP).
Setting the Protocol for Listen
Mode
Listen mode waits for a host to
connect to the specified port and
receives data. Listen mode can
be used with TCP (select port number) or LPD (no need to specify port)
protocols.
1. Select the Connection Mode as Listen.
2. Select the Protocol as TCP or LPD. Do not use UDP.
3. Select the Port.
Setting the Protocol for Call Remote Mode
Call remote mode initiates the data transfer. Call remote can be used for
TCP (select port number) or Telnet (no need to specify port) protocols.
1. Select the Connection Mode as Call Remote.
2. Select the Protocol as TCP or Telnet from the Card Configuration
screen. Do not use UDP.
3. Specify the Remote IP Address.
4. Select the Port.
5. Enter the amount of Retries in milliseconds after a failure before a
connection is tried again.