Avery Dennison 9460IP Setup Guide - Manual (Page 7)

7
Setting the Call/Listen Mode
This option sets the connection mode to Call or Listen.
1. From the Configure menu, select Call/Listen.
Call/Listen
P P Listen
X Call
E D
The choices include Listen or Call. Call mode initiates the transfer of
data. Call mode can be used for TCP or Telnet protocols. Listen
mode waits for a host to connect to the specified port and receives
data. Listen mode can be used for TCP or LPD protocols.
2. Use the A button under the D icon to select the connection mode you
want. Press the A button under the E icon to save the setting. For
example, if you select Call, you will see
Port
+ 09100
E R +
In Listen mode, this is the listen port.
In Call mode, this is the call port.
Use the A buttons as shown in the following table:
E
Press A to R
Press A to +
Press A to
Saves the setting Scrolls through the positions
from left to right Toggles between + or –;
also
Increments the current
position setting by 1
3. When the setting you want is displayed, press the A button under the E
icon to save the setting.
Remote IP
192.168.069.200
E R +
In Call mode, this is the remote IP address you are calling.