Avery Dennison 9460IP Setup Guide - Manual (Page 8)

8
Use the A buttons as shown in the following table:
E
Press A to R
Press A to +
Press A to
Saves the setting Scrolls through the positions
from left to right Increments the current
position setting by 1
4. When the remote IP setting you want is displayed, press the A button
under the E icon to save the setting.
5. Press the F button to exit. You return to the Configure menu.
Setting the Protocol
This option sets the protocol.
1. From the Configure menu, select Protocol.
Protocol
P P TCP
X Telnet
E U D
The choices include DLP, UDP, TCP, Telnet, or LPD. The most
common options are TCP and LPD for AS400 or Unix systems. Do
not use UDP.
2. Use the A buttons under the U or D icons to select the protocol you
want. Press the A button under the E icon to save the setting. You
return to the Configure menu.
Setting the Transfer Mode
1. From the Configure menu, select Transfer.
Transfer
P P Stream
X Frame
E D
The choices include Stream or Frame.
2. Use the A button under the D icon to select the transfer mode you
want. Press the A button under the E icon to save the setting.
3. Press the F button to exit. You return to the Configure menu.