Avery Dennison Rewinder - Manual (Page 13)

Manual Rewind Option
06/01 Rev. 2.09 13
Tooth belt tighten part
The tooth belt tighten part is used to tighten the tooth belt in a proper way - this means
mechanical tolerances given by production and assembly can be controlled.
Assembly/Disassembly tooth belt tighten part
• open two cross recessed screws and
the back cover part can be removed
• remove cover carefully over the stepper
motor
• as well during assembly and
disassembly the wires should be
watched
• the two hexagonal screws of the
tighten part are now visible
• the screw in the long hole is used to
tighten the belt
• open the screw - move the part in the
direction you think of and close the
screw
• to remove the tighten part the roll profile
and the guiding disc have to be removed
before (see roll profile and guiding disc)
Tooling
cross recessed head size 1
hexagonal socket SW 3