Axel AX4010 Installation Guide - Manual (Page 8)

Installation
________________________________________________________________
Installation Guide - AX4010 Office Server
5
Warning: Only use the Axel external transformer supplied with your
AX4010. Use of any other transformer may cause permanent damage to
the AX4010.
2.2.3 - Power On
The power switch on the rear panel controls the power supply to the AX4010.
1 : ON
0 : OFF
The green LED (ON/OFF), on the front of the AX4010, should light to indicate
that it is powered up and operating correctly.
The 'LNK' LED indicates a satisfactory connection to the Ethernet circuit (server
or hub).
At boot time, if no IP address is currently set, three RARP requests are
automatically broadcast (the Ch4 and Ch3 leds flash). Three BOOTP requests
are then automatically broadcast (the Ch2 and Ch1 leds flash). If no RARP
server or BOOTP server answers, the 8 leds (Ch1 to Ch4 port) remain lit until
an IP address is set.