Baby Lock Diana (BL480A) Instruction and Reference Guide - Manual (Page 23)

22
Thread the eye of the center needle.
Note: Use of tweezers in the accessory case will make
needle threading easy.
The position of the thread must be behind the thread
guide for overlock stitching.
Draw about 10cm (4 inches) of thread through needle eye
to hang free.
Place the thread to the back, and slightly to left under the
presser foot.
Before threading eye of needle, slip thread behind thread guide
located on the bottom of the needle clamp.
Before threading eye of needle, make sure thread is in front of
thread guide located on the bottom of the needle clamp.
Note: A. For 4 thread overlock left needle: Use needle
Note: For chain stitch :Use needle D.
3
10cm
(4")
9
8
5
7
9 9
3
6
4
While holding thread with finger, pass it between the tension
discs and pull thread down to make certain it is properly
located in between the tension discs.
3
9
4
5
6
7
8
Slip thread behind metal guide and into center slot on thread
guide.
Pass thread into the slot of take-up lever cover.
Position thread into the center slot on the guide located at
base of take-up lever cover.
Slip thread from left to right into the thread guide located
on bottom of the needle clamp. Position the thread into the
center section of the guide.