Baby Lock Eclipse DX (BLE1DX-2) Instruction and Reference Guide - Manual (Page 13)


Upper Looper
1. With the presser foot up and machine lock button in the locked position (fig.A, page 10), set
the looper threader selector lever to "U" for upper looper threading. (fig.B, page 10)
2. Place the thread cone or spool on the second spool pin from the right back. Slip the thread
into the telescopic antenna thread guide "A" directly above the spool, snap into the thread
guide "B" at the top of the front of the machine, through the slot on the front cover. (fig.C,
below)
3. Pull 18 inches (45cm) of thread through guide "C". Insert the end of the thread into the
threading port "U", about 1 inch (2.5cm). Use tweezers, if necessary, to insert the thread end
more easily. (fig.D below)
4. Depress the looper threader lever (fig.D below). If the thread does not go through the upper
looper eye with one push, depress the looper threader lever again until it does, and leave
thread hanging loose.
5. Move the lock button release lever to the right, to unlock the machine.
S
E
R
G
E
R
S
E
T
U
P