Baby Lock Eclipse DX (BLE1DX-2) Instruction and Reference Guide User Manual
Page 20
E
C
L
I
P
S
E
M
A
C
H
I
N
E
S
E
T
T
I
N
G
S
Disengaging the Upper Cutting Blade
Presser Foot Pressure
Snap-On Presser Foot
The Eclipse has the convenience of a snap-on presser foot.
To Release:
1. Raise the presser foot lever.
2. Lower the cutting blade.
3. Raise the needles to the hightest position.
4. Push the presser foot release lever located at the back of the
presser foot holder.
5. Carefully turn the presser foot clockwise 90 degrees.
6. Slide the presser foot to the rear to remove.
To Replace:
1. Raise the presser foot lever.
2. Lower the cutting blade.
3. Raise the needles to the lightest position.
4. Slide the foot from the left to right.
5. Align the bar of the foot with the groove in the holder.
6. Lower the presser foot lever to snap into place.
The presser foot that comes with the Eclipse has a tape sewing slot.
Insert the tape or ribbon, into the slot in the front of the foot, then
under the sole of the foot. (see page 23 for more instruction)
The raised markings on the toe of the foot are seam line guides.
They indicate the needle positions to help guide your fabric for
accurate seaming.
Presser Foot
Release Button
Seam Line
Guides