BDI 3470 Continuum - Manual

1
4mm and 5mm Allen Wrench
A - 1/4 - 20 Screw x 3
Mirror
Panel
Pre-assembled
Panel
Base
Your Continuum Furniture is engineered for easy assembly. Carefully
follow this procedure to prevent any damage.
Placement and Maintenance
Clean glass with glass cleaner. Clean steel parts and wood veneer with a
moist cloth.
Step 1
Unpack and identify the parts listed. The assembly workspace should be a
non-marring surface such as carpet. For missing hardware pieces please
contact BDI Customer Service at [email protected]. For all
other concerns, please contact your BDI Retailer.
Step 2
Attach base to frame.
As shown below, lay pre-assembled panel on its side so that base can be
easily installed. Line the hole of the base with the extended stud on the
bottom of the frame then using the 4mm allen wrench, attach base to
bottom of frame with Countersunk Screws (A).
The 5mm allen wrench is supplied in case the wood panel
swivel mechanism is not tightened properly. Please keep this
tool in case the swivel mechanism loosens over time.
Component List
Designed by Matthew Weatherly.
These distinctive product configurations are protected by US and
international patents, trade press, and/or copyright laws.
‘Continuum’ is a trademark of Becker Designed, Inc.
All rights reserved. ©2009 Becker Designed, Inc.
Made in China. 3470REV102609v4
C
o n t i n u u m
3470
a s s e m b l y i n s t r u c t i o n s
bdiusa
.
com customerservice
@
bdiusa
.
com
A x 3
Important: Use precaution when
attaching base to frame. Top surface of
base may scratch.