Beurer FW 20 - Manual (Page 10)

10
• Cleaning and user maintenance must not be performed by children
unless supervised.
• This foot warmer is not designed for use in hospitals.
• This foot warmer must not be used to keep animals warm.
• Do not use this foot warmer with shoes.
• Do not insert needles.
• Do not use when folded or bunched up.
• Do not use if wet.
• The electrical and magnetic fields emitted by this foot warmer may
interfere with the function of a pacemaker. However, they are still
well within the limits: electrical field strength: max. 5000 V/m,
magnetic field strength: max. 80 A/m, magnetic flux density: max.
0.1 millitesla.
Please consult your doctor and the manufacturer of your pacemaker
before using this foot warmer.
• Do not pull, twist or make sharp bends in the cables.
• Please check this foot warmer frequently for signs of wear and tear
or damage.
If any such signs are evident, if the foot warmer has been used
incorrectly or if it no longer heats up, it must be checked by the
manufacturer before being switched on again.
• If the mains connection cable of the foot warmer is damaged, it must
be replaced by the manufacturer, its customer service department or
a similarly qualified person to avoid any risk.
• The electronic components in the controller warm up when the foot
warmer is in use. For this reason, the controller must never be covered
or placed on the foot warmer when it is in use.
• Always observe the notes on operation (section 4), cleaning and
maintenance (section 5) and storage (section 6).
• If you should have any questions about using our devices, please
contact Customer Services.
3. Intended use
cAutION
This foot warmer is intended only for heating human feet.
4. Operation
4.1 safety
cAutION
the foot warmer is fitted with a SAFETY SYSTEM. This sensor technology provides protection against
overheating across the entire surface of the foot warmer with an automatic switch-off in the event
of a fault. If the SAFETY SYSTEM has switched off the foot warmer, the temperature settings (4) are
no longer illuminated when switched on. Please note that, for safety reasons, the foot warmer can
no longer be operated after a fault has occurred and must be sent to the specified service address.