Beurer FM 60 - Manual (Page 12)

12
9. Operation
Remove your shoes before each use. When seated comfortably, place your feet on the massage heads. The
device is prevented from slipping by the rubber feet on the base of the device.
Switch on the massager firstly at the main switch and then with the on/off button. To switch on the heat
function and the 2nd speed setting, press the on/off button again. Press on/off again to switch off the device.
For an optimum massage position, the rear feet can be adjusted. Rotate the feet higher in a clockwise di-
rection or lower in an anti-clockwise direction.
The massage must be pleasant and relaxing at all times. Stop the massage or change your position or the
contact pressure if you find it is painful or unpleasant.
• Do not force any part of your body, in particular your fingers, between the rotating massage heads and
their mountings in the device.
Note
• Do not use the massage device for longer than 15 minutes. Otherwise, using the device for longer
can over-stimulate the muscles and cause tension instead of relaxation.
Massage of a specific point on the sole of the foot may influence the corresponding organ of the body.
However, we recommend studying relevant literature and asking your doctor before using point reflex
zone massage to achieve the desired effect.
10. care and storage
cLeANING
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Clean the instrument with a slightly moistened cloth. You can also moisten the cloth with mild soap
suds to remove more stubborn dirt.
• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
11. In the event of problems
Problem cause Remedy
Massage heads
rotating at
reduced speed.
The load on the massage
heads is too great. Release the massage heads.
Massage heads
not moving.
Appliance not connected to
the power supply. Connect the mains plug and switch on the device.
Set the main switch to 1.
12. Disposal
cAUTION
Please dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and
Electronic Equipment).
If you have any queries, please contact the appropriate local authorities.