Beurer MG 200 - Manual (Page 14)

14
8. Care and storage
Cleaning
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
• The removable cover is machine-washable at 40 °C. Please follow the cleaning and care symbols
on the label which is sewn into the cover.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
Alternatively, you can hang the device in a wardrobe with a coat hanger. To do so, the coat hanger must be
threaded through the hanging loops on the rear side of the device.
CAUTION
• If you use the screw for transport locking, take care when using the device again that it is definitely
removed before switching on.
9. In the event of problems
Problem Cause Remedy
Massage heads rota-
ting at reduced speed.
The load on the massage
heads is too great.
Reduce the contact pressure on the head.
Massage heads only
rotate in the upper or
lower region.
The massage has been
activated for the limited
region.
Press the full back/upper back/lower back
buttons to change or extend the area.
Massage heads not
moving.
Appliance not connected to
the power supply.
Connect the plug to the mains supply and
switch on the appliance.
Device not switched on. Switch the device on with .
Select the massage region.
Transport lock has not been
removed, the massage
mechanism is damaged.
Contact your authorized dealer or the service
address.
Overheating protection
tripped, device is damaged.
Contact your authorized dealer or the service
address.