Dish Network VIP 722 - Manual (Page 13)

Remote Controls
83
Sending Discrete Power On and Off
Removing the Recover Button Channel Programming
The following instructions describe how to reset RECOVER to restore satellite TV viewing by
tuning your TV (or VCR) to channel 3, 4, and other inputs.
Sending Discrete Power On and Off
Installers use remote control discrete power On and power Off IR commands when programming
macro commands into universal remotes. Using an On-only or Off-only command is more effective
than a toggle On/Off command when trying to make sure the satellite receiver is reliably in one
state or the other. To use discrete power commands, complete the following:
Tips
• If using a specific channel for TV2 (for example, channel 60), TV2’s remote control must be
programmed with a TV2 channel before you can use RECOVER.
• Place the channel sticker on the remote TV and write down the channel you use to watch
DISH Network programming. The stickers are inside the front cover of this guide.
• If you don’t want to accidentally change channels on your TV or VCR, the remote control in
Limited Mode as described on page 75.
• Make sure you have a remote control antenna connected so you can use Remote Control 2.
See page 17 for instructions.
1
2
3
4
Press and hold the
TV Mode button until all
Mode buttons light up
(button will flash)
Press STAR
TV
Press the
Zero button
3 times Press POUND
(TV Mode button
will flash 3 times)
1
2
3
5
4
or
Program the
remote control
Press
POWER
Press
SAT Mode
until all mode
buttons light up
Press VOLUME UP
for discrete power on
or press VOLUME DOWN
for discrete power off
SAT
Press any
button
to end this
procedure
VOLUME
VOLUME
#
R
DVR
SELEC T
PO WE R TV SAT
VC R AU X
TV
TV/V ID EO
VO LUM E
MENU
PA GE
MU TE
GU ID E RE CA LL
CA NC EL
IN FO SK IP BA CK
BA CK
SK IP FW D
FW D
PA US E STO P
PLAY RE CO RD PIP
/FO RM AT
abc
def
ghi
mn o
jkl pqrs
wxyz
tuv
T H E M E S
B R O W S E
P A W S
PO SI TIO N
1
1
2
3
4
5
6
7 8
0 9