Dish Network VIP 722 - Manual (Page 6)

Chapter 10
76
Controlling Other Components
Setting Up Using Device Code Tables
Set up the remote to control other devices using the device codes listed on page 132. In the
instructions below, the column on the left contains the instructions and the column on the right
provides additional information.
Instructions Additional Information
1. Turn the device on. Use the device’s front panel buttons or its remote control.
2. Find the brand name of the device in the
tables starting on page 132. If the brand isn’t listed, see Setting Up Using Device Codes
Scan on page 77.
3. Press and hold the mode button until all the
other mode buttons light up, then release
the button. The mode button flashes. For example, for a TV, hold the TV mode button until all of
the other mode buttons light. When you let go, TV will flash.
4. For AUX mode only. Press 0 for a TV, 1 for
a VCR, or 2 for a tuner or amplifier. If you’re not programming in AUX mode, skip to step 5.
5. Enter one of the three-digit device codes
from the table using the number buttons. The three-digit device code is for the brand name of your
device that you found in step 2.
6. If you want to program Limited Mode, press
1. If not, skip to step 7. See Limited Mode for more information.
7. Press POUND (#). If you entered the code correctly, the mode button flashes
three times.
8. Press POWER to turn off the device. If the
device does not turn off, go to step 10. If the code works, the device should turn off.
9. Turn the device back on and try some other
buttons to make sure they work. If the code
works for other buttons, stop here. Sometimes POWER works when other buttons don’t. If in
Limited Mode, try VOLUME or MUTE.
10. If the code doesn’t work, repeat steps 3
through 9 with another device code from
the tables.
Try every code listed for your brand until one works for your
device.
11. If you can’t find a code that works try,
Setting Up Using Device Codes Scan that
follows.
1
2
3-4
7
5-6
8
Turn
device on
Find code in
tables
Press POWER
to see if device
turns off
Test to make
sure code
works
Press & hold
Mode button
until all Mode
buttons light up
VCR
#
9-11
Enter code
from table
Press
POUND
VCR
VCR