Blu Bathworks SA0110 - Manual (Page 3)

1 866 907 0122 blubathworks.com
2014-01
®
2
1
2
3
Installation Instructions for Semi-Recessed Basin
SA0110
Refer to Illustrations below.
• Locate the appropriate position on the vanity top
where the basin will be installed.
• Ensure that there is enough room under the vanity
top for the faucet water supply lines, drain assembly
and bottom of basin.
• Spacing between the basin and backsplash of vanity
should have enough distance to accommodate desired
faucet (for deckmount faucet installation).
• Ensure the cut-out line is centered on the vanity.
• The outer diameter of the hole should be cut to
accommodate the basin. We recommend a diameter of
15 1/6” [385mm].
NOTE: The recommended diameter of 15 1/6” [385mm]
is after polishing the countertop (if polishing is required).
• Confirm that the mark on the vanity aligns with the
basin.
• Then make a clearance hole anywhere inside the
cut-out line and cut around the cut-out line.
• Refer to manufacturer’s drilling guide for relevant
countertop material guidelines.