Blu Bathworks TSP131 - Manual (Page 5)

2013-07
1 866 907 0122 blubathworks.com
®
4
INSTALLATION STEP 2
• Position the O-ring (2) in its site on the nut (1).
• Screw the nut (1), as per drawing (A), on the threaded rod(3).
• Place the O-ring (4) on its site on the nut (5).
• Screw the nut (5), as shown in the drawing (A), on the mixer body
(6).
• Once the correct position of the rings is reached, tighten the nuts
located under the wash basin mixer to fix the rod and the mixer
body.
• (A)
INSTALLATION STEP 3
• Place the two small cover plates (1)
• Place the O-ring (2) and screw the cap (3) to secure the cover plate
of the mixer body.
INSTALLATION STEP 3
• Place the two small cover plates (1)
• Place the O-ring (2) and screw the cap (3) to secure the cover plate of the mixer body.