Denon TU-1510AE - Manual (Page 9)

5
ENGLISH
Getting
started
Connections
Operations
Troubleshooting
Specifi
cations
Index
Tuning in radio stations
Turning the power on
n Setting the power to the “on” mode
Press <ON/STANDBY> or [POWER] .
• The display lights and the unit becomes operable.
n Setting the power to the “standby” mode
When the power is in the “on” mode, press <ON/STANDBY>
or [POWER] .
• The power is set to the “standby” mode.
• The unit is also equipped with a back-up memory. This function
provides memory storage when the power switch is off and with the
power supply cord disconnected.
NOTE
Power continues to be supplied to some of the circuitry even when
the power is in the standby mode. When leaving home for long
periods of time or when going on vacation, unplug the power cord
from the power outlet.
Listening to FM/AM broadcasts
1
Press BAND to select “FM” or “AM”.
FM
AM
When listening to an FM broadcast.
When listening to an AM broadcast.
2 Tune in the desired broadcast station.
Auto tuning (FM/AM)
q Press [AUTO/MANU] to set “AUTO”.
• When the auto tuning mode is set, “AUTO” appears to the right
of the frequency on the display.
w Press [TUNING d , f ] .
• Auto tuning starts.
• Press the
[TUNING d ] to automatically switch to higher
frequencies, the [TUNING f ] to automatically switch to lower
frequencies.
• TUNED indicator lights and tuning stops when a frequency whose
strength is at or above a specifi c level is tuned in.
• STEREO indicator lights when a stereo broadcast is received on
the FM band.
Manual tuning (FM/AM)
q Press [AUTO/MANU] to set the manual tuning mode.
• When the manual tuning mode is set, the word “AUTO” shown
to the right of the frequency on the display turns off.
w Press [TUNING d , f ] .
• Press and hold in [TUNING d ] to move to higher frequencies,
[TUNING f ] to move to lower frequencies.
• Use the manual tuning mode to tune in stations whose signal is too
weak to tune in using the auto tuning mode.
• In the manual tuning mode, the signals are forcibly set to monaural,
and STEREO indicator does not light even when receiving stereo
broadcasts on the FM band.
Operations
Button located on both the main unit
and the remote control
BUTTON
Button only on the main <BUTTON>
Button only on the remote control [BUTTON]
Symbols used to indicate buttons in this manual
<ON/STANDBY> BAND
STEREO indicator TUNED indicator
[POWER]
BAND
[TUNING d, f]
[AUTO/MANU]
Operations