BSS Audio FDS-355 OMNIDRIVE Owner's Manual - Manual (Page 15)

15
Rear panel
5.3 Rear panel
Fig 5.3 Rear panel
A Mains power input
The Power inlet for the FDS-355. Note that there is no On/Off switch for the
unit.
B Fuse
C RS-232 connector
For connection to a PC for access to one or more FDS-355s on a MIDI loop,
which provides an easy way to upload new software.
D MIDI interface connectors
E 5 Band outputs
The FDS-355 audio outputs are electronically balanced and floating.
Transformer balancing is available as a retrofit option.
Pin 1 Shield/Ground
Pin 2 Signal Hot (+)
Pin 3 Signal Cold (-)
F 3 Channel inputs
The FDS-355 audio inputs are electronically balanced. Transformer balancing
is available as a retrofit option.
Pin 1 Open circuit
Pin 2 Signal Hot (+)
Pin 3 Signal Cold (-)