BUG-O Systems Flame Cutting - Manual (Page 16)

16
5. BUG-O SYSTEM (PORTABLE)
a. The BUG-O should be in good condition
so it will travel smoothly and at a steady speed.
(1) Check the wheels to make sure there are no
burrs or spatter stuck to them. They should
be smooth and clean and rotate freely.
(2) The speed adjustment knob should turn
smoothly to allow speed-up or slow-down from
one setting to the other.
(3) The track ways or “grooves” should be
periodically brushed clean. This removes
particles that could obstruct the wheels and
ruin the cut. The track should be straight with
no burrs or nicks in the grooves.
(4) If the BUG-O or track is damaged or does not
work well, have it repaired.
Flame Cutting Handbook.p65 5/9/2007, 8:06 AM 16